• State Accepted Answer
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 2 replies
  • Subscribers 121 subscribers
  • Views 7868 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DS5: How to solve autodetect warning message with Platform Configuration Editor?

Emmy0

Hi experts,

     I use Platform Configuration Editor of DS5-v5.27 to generate debug&trace database of a Cortex-A73*4 SOC.

    After autodetect, there are some warning messages about component connections.

     The missing component connections are:

      1. CSTFunnel -> CSATBReplicator

      2. Cortex-A73_0 -> CSETM0

      3. Cortex-A73_1 -> CSETM1

      4. Cortex-A73_2 -> CSETM2

      5. Cortex-A73_3 -> CSETM3

    When I add item1(Funnel->Replicator), the slave list only shows TPIU and ETB, no Replicator is found.

    Item2~5: If I add item2~5 connections, Master CSETM_x only shows "Add Link From This Device", there is no "Add Link to This Device".   

    How I can identify the missing connections? or which points I can check cause the issues probably?

   Thanks for your attention!

Best Regards,

Emmy

Parents
  • 0 in reply to Lukas Snetler

    Hi Lukas,

         The videos you recommended are very useful for me, thanks!

         After I upgrade DS-5 software to v5.28.1 and upgrade DSTREAM firmware to v4.33.0, PCE autodetect can work well and no warning  messages are generated.

          The SOC I used is Cortex-A73*4. I just want using PCE autodetect to check Coresight component connections are right or not.

          Thanks for your attention!

    Best Regards,

    Emmy

Reply
  • 0 in reply to Lukas Snetler

    Hi Lukas,

         The videos you recommended are very useful for me, thanks!

         After I upgrade DS-5 software to v5.28.1 and upgrade DSTREAM firmware to v4.33.0, PCE autodetect can work well and no warning  messages are generated.

          The SOC I used is Cortex-A73*4. I just want using PCE autodetect to check Coresight component connections are right or not.

          Thanks for your attention!

    Best Regards,

    Emmy

Children
No data