• State Accepted Answer
  • Locked Locked
  • Replies 2 replies
  • Subscribers 119 subscribers
  • Views 4879 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Driving nTRST and nSRST signals through ARM DS-5

Amit

Hello All,

              I have connected my target board via a JTAG connector to ARM DStream and using ARM DS-5 to debug it. I would like to know the mapping of nSRST and nTRST reset signals of ARM DS-5 eclipse environment. Does Connect/Disconnect to target drive the nTRST signal and Reset.system drive the nSRST signal through DS-5 ? Please correct my understanding if I am wrong.

Also, I would like to know is there any other method (any command line utility) to drive these signals without ARM DS-5 ? Please help. Thanks in advance.