This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Dual A53 cluster, MMU configuration

Hello,
we have a A53 cluster with two cores, core 0 and core 1.
is there any possibility that the MMU configuration of core 1 is only done by core 0?since on core 1 a non secure application is running.

after core 0 has done the MMU setup for Core 1, it should be forbidden for core 1 to change this its MMU configuration

thanks

Majid

Top replies

Martin Weidmann over 3 years ago in reply to Majid Ghameshlu +2 suggested

Majid Ghameshlu said: would it be OK, if we now assume a hypervisor on core 1 which takes care of e.g. MMU configuration and the unsecure application runs under the control of this hypervisor? In principle...

Parents

0 Majid Ghameshlu over 3 years ago in reply to Martin Weidmann

Hallo Martin,
we want to guarantee that core 1 has at maximum 20% load of AXI master interface of A53 MPCORE and the core 0 80%.
is there any QoS features inside the A53 MPCORE?
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Majid Ghameshlu over 3 years ago in reply to Martin Weidmann

Hallo Martin,
we want to guarantee that core 1 has at maximum 20% load of AXI master interface of A53 MPCORE and the core 0 80%.
is there any QoS features inside the A53 MPCORE?
Cancel
Vote up 0 Vote down

Cancel

Children

No data