I bought an ARM LPC2148 Development board and started uploading code in it. I wrote the code to blink the on-board 4 LEDs. It gets uploaded successfully in the board but the LEDs never blink (leave alone the blinking according to the code). I have rechecked the code again and again. I am getting 0 V on the pins(P1.16, P1.17, P1.18, P1.19) to which the LEDs are connected. I cannot figure out why this is happening. Help!!
The code is:-
#define LED2_ON() IO1SET=(1<<17)
#define LED3_ON() IO1SET=(1<<18)
#define LED4_ON() IO1SET=(1<<19)
#define LED2_OFF() IO1CLR=(1<<17)
#define LED3_OFF() IO1CLR=(1<<18)
#define LED4_OFF() IO1CLR=(1<<19)
{
unsigned int i;
for(;j>0;j--)
for(i=0; i<60000; i++);
}
int main(void)
PINSEL1 = 0x00000000;
PINSEL2 = 0x00000000;
LED1_ON();
Delay(25);
LED1_OFF();
LED2_ON();
LED2_OFF();
LED3_ON();
LED3_OFF();
LED4_ON();
LED4_OFF();
return(0);
Have you tried doing your exercises on PORT0?
In this LED sequencer, you may want to replace IO1SET, IO1CLR, and IO1DIR with IO0SET, IO0CLR, and IO0DIR respectively in your code (save the modification in a different project) and connect the separate LEDs to P0.16, P0.17, P0.18, P0.19. Try if the code will work, this will tell whether the problem is confined only to PORT1 or will also manifest on PORT0.