This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Keil MDK Simulation keeps executing the first line assembly code

I tried to simulate the instruction execution on Arduino nano 33 ble sense. So using Keil MDK, I selected nrf52480 as a device for simulation and used the initialization file to debug from the main function. But when I started debug session, the simulation stayed at the first line assembly code at the address 0x00000000. I doubted that I haven't set up the right value of CPU DLL and Dialog DLL. The default value of CPU DLL is "SARMCM3.DLL -MPU" and that of Dialog DLL is "DCM.DLL -pCM4". Very appreciate it if someone can answer my question. 

Parents
  • Using the "led_softblink_pca10040 (nRF52 PCA10040)" example project from the Pack Installer of uVision, when i set the simulation parameters like these

    The core simulation works fine for me as shown here

    The peripheral simulation for this device is not support.

Reply
  • Using the "led_softblink_pca10040 (nRF52 PCA10040)" example project from the Pack Installer of uVision, when i set the simulation parameters like these

    The core simulation works fine for me as shown here

    The peripheral simulation for this device is not support.

Children