This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Don't stop debugging on startup

During some integration tests of my embedded system, the firmware is being reset multiple times. (Software reset. The power is always on)
I would like to run the firmware in debug mode to collect some coverage data during testing. 

Now on every reset, the debugger stops at the main() function. 

Is there a way to turn this off?
This is very annoying since it makes it impossible to run these automated tests in debug mode.

I'm using the ULINK Pro Cortex Debugger.

Parents Reply Children