ST-link doesnt run the MCU after programming and reset in KEIL 5.33

Hello,

I have updated my KEIL from 5.15 to 5.33. In KEIL 5.15 I set Reset and Run option in Flash->Configure Flash Tools->Debug( Selecting St-link) Settings->flash download and after programming my MCU start working. However, after updating KEIL to 5.33 it just program my MCU and I should power off/on my MCU to start working. I need to know what it the problem with this new version of KEIL.

More questions in this forum
There are no posts to show. This could be because there are no posts in this forum or due to a filter.