Good day to you all! Now I have another problem with the DEBUG I got this error "device could not be powered" and in the Build output message it is as follows:
I use the ULINK2 debugger to program a SAMD21G18A from ATMEL, Thanks for helping me with the problem of unnamed reserve bits but now this problem came up, thanks in advance and I hope your answer soon.
You didn't give the link to your original post:
https://community.atmel.com/forum/device-could-not-be-powered-samd21
Please also update that thread with a link to this - as advised.
antouriel123 said:I got this error "device could not be powered"
You still haven't explained where, exactly, you see that message or what you're doing when it happens.
antouriel123 said:program a SAMD21G18A from ATMEL
What board is it on?
If it's your own custom board, how have you proved that the board design is correct, and the hardware good?
Before going to a custom board, have you been able to program a chip on a known-working Dev Board or similar?
I was able to solve the problem, I reloaded the bootloader of the arduino MKRZero with ATMEL ICEthey got in the company, thank you.I didn't know you were also at ATMEL COMMUNITY.A thousand apologies!
You still need to update your thread on the Atmel Community.