Good day to you all! Now I have another problem with the DEBUG I got this error "device could not be powered" and in the Build output message it is as follows:
I use the ULINK2 debugger to program a SAMD21G18A from ATMEL, Thanks for helping me with the problem of unnamed reserve bits but now this problem came up, thanks in advance and I hope your answer soon.
See: related "Error Messages"
and check your ULINK2 with the help of this Troubleshooting Guide:
Hello, Good Morning!I already checked the ULINK2/ME and it works with the steps you provided me so the fault is in the microcontroller, now my doubt is, in these cases can the microcontroller be unlocked with the same ULINK2 And if I could indicate to the Keil uvision IDE, because I was consulting precisely the manuals and they said that to make the reset operation it was according to each microcontroller, is it true? or also I found this, I don't know if this information is valid?
At MDK's Flash Download Option configure for 'Erase Full Chip' and retry.
It also would be worth contacting the Chip vendor themselves for details.
many I will try to contact the distributor to see if I can find an answer
View all questions in Keil forum