This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

microsemi smartfusion keil and softconsole

The hex file ouput of keil and Softconsole are different.

After loading the keil hex file into flashpro and programming it to a2f-eval-kit, there is no output displayed on UART.

But the functionality is proper with softconsole hex file.

From what i have read, both of them produce intel hex file as output.

How to get the same output as that of softconsole using Keil.

Thanks

Parents
  • i followed the process showed in documentation

    Then you need to contact Microsemi for any corrections and/or updates to their documentation!

    Did you see the "Important Notes" at the end of the linked SoftConsole page?

    It says:

    "Please read the release notes for the relevant version of SoftConsole to be aware of all relevant features, known issues, troubleshooting tips etc"

    Have you done that - in particular, applying the "troubleshooting tips" ?

    There is also a 'Support' link at that top of that page.

Reply
  • i followed the process showed in documentation

    Then you need to contact Microsemi for any corrections and/or updates to their documentation!

    Did you see the "Important Notes" at the end of the linked SoftConsole page?

    It says:

    "Please read the release notes for the relevant version of SoftConsole to be aware of all relevant features, known issues, troubleshooting tips etc"

    Have you done that - in particular, applying the "troubleshooting tips" ?

    There is also a 'Support' link at that top of that page.

Children
No data