Hello,
I'm new to the ARM-world and want to program an ATSAM3U4C.
My problem is to adjust the correct clockspeeds because the data sheet is really complicated.
Is there anyone who could tell me what I have to program to get the PLL to 96MHz?
Regards
EnochRoot
Note that this has nothing to do with ARM; this is a manufacturer-specific implementation detail - so you really need to go to the manufacturer's documentation & support for this question.
https://www.microchip.com/wwwproducts/en/ATSAM3U4C - see the 'Documents' tab.
https://community.atmel.com/atmel-smart-arm-based-mcus
Have you looked at Atmel Studio to see what examples are provided ?
Or Atmel START ?
To understand what "belongs" to ARM, and what is manufacturer-specific, see:
https://community.arm.com/developer/tools-software/tools/f/keil-forum/43684/lpc2148-timer0-not-working-as-expected/158950#158950
Hello Andy,
thanks for your reply.
I tried to use the example programs provided by AtmelStudio7 but unfortunately have found no solution yet.
Kinde regards
Enoch
Again, the place to ask about that is in the Microchip SAM forum: it has nothing to do with Keil or ARM - it is entirely proprietary and specific to the SAM parts.