I recently updated to Keil MDK 5.28, and everything worked fine till i downloaded my software and try to start it on my board. Upload worked perfectly like on last version (5.26). Then i noticed that board does not start and i found out that my ST-LINK/V2 debugger does not produce reset signal after upload. I checked settings and my (Reset and Run) function is checked and i also put osciloscope on reset pin and result is as expected (no signal after upload). I upgraded STLINK on latest firmware.
Does anyone have same problem?
Thanks for any help!
1. For my understanding - Is this setting still working with MDK 5.26?
2. Probably there are example projects existing, offered by the Pack Installer:
Whats the result if you compare with one of these projects?
1. Exactly it worked on 5.26 if i will get instalation fille i will try to downgrade.
2. I tried this suggestion but same result it does not work.
I belive i have got problem in this part, picture below. Because when i hit "Download" reset pin occoures on osciloscope but after finishing downloading software does not occur.
View all questions in Keil forum