I recently updated to Keil MDK 5.28, and everything worked fine till i downloaded my software and try to start it on my board. Upload worked perfectly like on last version (5.26). Then i noticed that board does not start and i found out that my ST-LINK/V2 debugger does not produce reset signal after upload. I checked settings and my (Reset and Run) function is checked and i also put osciloscope on reset pin and result is as expected (no signal after upload). I upgraded STLINK on latest firmware.
Does anyone have same problem?
Thanks for any help!
1. For my understanding - Is this setting still working with MDK 5.26?
2. Probably there are example projects existing, offered by the Pack Installer:
Whats the result if you compare with one of these projects?
Does 'Reset & Run' necessarily use the hardware reset signal ... ?
see i.e. : http://www.keil.com/support/man/docs/ulink2/ulink2_ctx_debug.htm
Thanks, R.Kopsch - so whether or not it's used is configurable.
So, SebaC - is your project configured to use the hardware reset line?
Currently i use "Autodetect" function, but i also tried "HW RESET" but it does not help.
Problem is that in "DEBUG" mode if i hit "RESET" or "RUN" program start as expected.
I belive i have got problem in this part, picture below. Because when i hit "Download" reset pin occoures on osciloscope but after finishing downloading software does not occur.
1. Exactly it worked on 5.26 if i will get instalation fille i will try to downgrade.
2. I tried this suggestion but same result it does not work.
I have same problem and I think it's a bug in 5.28a
Did you solve it ?
Sorry not jet.
View all questions in Keil forum