I got a discovery kit .(stm32l discovery kit) when i try to load some basic
blinky code to my processor - after the compiling - I got some error mesage ;
"No target connected " and "Error : Flash download failed target dll has been canceled "
after this message i did some actions for solving this problem (for example ;
I did ; Utilities --> Debug ---> Connect ---> Choose ,Reset after Connect) but
I am demanding your valuable suggestions...
Demand is a bit strong.
To stop your code running on the board, strap BOOT0 HIGH. If this allows connectivity, something wrong with your code, or settings/options.
The debugger cannot connect if power is removed from the debug circuitry (enters a low power mode, etc), or the pins used are reconfigured.
Check and update the firmware in the ST-LINK also, probably quite old.
thanks a lot. İ will try these. ;)
View all questions in Keil forum