I meet a confusing problem... I have to use UART & IIC communication simultaneously. The internal SCL generator is selected for the I2C clock. data rate is 100Kbit/sec at fosc=12MHz. Baudrate generator is selected for UART clock. 9600bps is set. The problem is that IIC works incorrectly if baudrate generator for UART is set enable. It always halts after transmitting/receiving one or two bytes of data and can't finish whole communication properly. How to solve this problem ? Thanks...
Hello Mike, I'm sorry that I can't understand your meaning precisely. would you please describe it clearly? thanks. Hi Erik, I haven't downloaded my program to 932 chip. In fact I just emulated the function on EPM900 ICE. However, I'll remember your advice when I use Philip MCU in future. Thanks.
Philips had some "birth pangs" with the 932. Thus it is important to know which revision your chip is. I must, however, commend Philips for their honesty, the errata has been kept complete (as opposed to Atmel). Erik
Hi willy, which step isn't it? F, G, AB, ... Mike
View all questions in Keil forum