Use of hex2bin for legacy project

Hello. I needed to make a firmware change to a legacy project. It is actually generated using TI's code composer, but I'm able to generate a hex file from there.

After reading the forums here and for TI, I see that this is not neccesarily how the program should be used, but I see hex2bin.exe in all previous firmware versions, and mentioned in design notes, though not how to actually use the program.

I am using this post for my research:
http://www.keil.com/support/docs/274.htm

With some experimenting, I have used this command in command prompt:
hex2bin V2AcqSys.hex [V2AcqSys.bin]

I'm not too familiar with this stuff, so I would appreciate any advice you could provide in this unorthodox situation.

Thanks for your time.
-Cam

More questions in this forum