Hello, I'm trying use new uVision5 and i don't know where is pariphery library for RTC and how it use. Can anyone help me with this?
Thank You Jan
"Don't any of you people Please read the manual?"
I prefer the movie. But not the new remake.
OK, but i think this libraries must be implemented in this development software. Without this files is unusable. I think, must be other ways without this files or not? If not, i must download files from STM site and use it same as in older versions?
Why do you think that?
"Without this files is unusable"
Nonsense - a competent programmer could write it all from scratch from the Datasheet, These libraries are purely a convenience to save you the effort.
" must download files from STM site "
Exactly - they are provided as source; you can build them using whatever tools you like.
I don't have time for write over 10 000 rows for only initialize periphery. If i write all initialize functions for used periphery i have 160 years... Without support this libraries i go install older version where i can programming my own code 10 minutes after create new project and initialize all needed peripherials. This new solution is one step forward and two steps back :-(
This new solution is one step forward and two steps back :-(
Why are you even looking at embedded? It is obvious that you are not capable of doing it.
10000 lines and 160 years. I must be many times older than Merlin or Gandalf if we assume the code I have written have grown at only 62 lines/year. And I have programmed quite a number of chips without any manufacturer library to allow me to assign to lots and lots of structs and then call helper functions.
View all questions in Keil forum