helo, am facing a problem when am interfacing my cypress development board to the keil...am able to load the monitor program to the board through cyconsole software...but not able to interface ...and the id detects the chip as CY7C647....need help...
Which debug monitor file do you use?
You'll find the debug monitor HEX files in this folder. C:\Cypress\USB\Target\Monitor\
In this folder, there are several monitor files. It depends on, - FX1 (E0) or FX2(LP) (C0) - load monitor to external XRAM (ext) or on-chip XRAM (int) - Serial port 0 (sio0) or 1 (sio1) the Readme.txt in the same folder documents it well.
Select one which fits to your target board configuration.
If you can't find the folder, download the DevKit installer on Cypress "CY3684 EZ-USB FX2LP Development Kit" page.
"SETUP_FX2LP_DVK_1004.exe" download.cypress.com.edgesuite.net/.../cy3684_ez_usb_fx2lp_development_kit_15.exe
Tsuneo
ho thanks a lot ...i have checked it.....but pls tell me that without the evaluation board and its software installed ...can we bring up our cypress developoment board connected to KEIL......i need my board to get connected to keil IDE.... as i read in one of the forum ...they say without evaluation board u cant connect ur system to KEIL...pls answer for this
Of course, you can connect the monitor (Keil MON51) to your custom board. To fit to your custom board, these variations are supplied.
If the debug monitor can connect only to the Cypress dev board, it isn't so helpful, isn't it?
View all questions in Keil forum