rpm selection

i m using a stepper motor of 1.8 degree step angle
i want to write a program which will control the speed of stepper motor i.e. on lcd ther is a rpm selection from 100 to 200 and according to that i want my motor to run. i m unable to write that program could u guide me for that?? thank u

Parents
  • "i'm unable to write that program"

    Why are you unable to write it?

    Do you not know anything about programming?

    Do you know some programming, but not microcontroller programming?

    Do you know microcontroller programming, but not how stepper motors work?

    It's impossible to help you if you don't say what help you need!

Reply
  • "i'm unable to write that program"

    Why are you unable to write it?

    Do you not know anything about programming?

    Do you know some programming, but not microcontroller programming?

    Do you know microcontroller programming, but not how stepper motors work?

    It's impossible to help you if you don't say what help you need!

Children
More questions in this forum