section located outside class

Hi,

on a XC164CS-16F I'm using data model medium. But I also have huge data. I had no problem so far. But now I added some new data and am struggling with the linker / locator:
I have added 3 modules that contain data of identical size that shall be stored in a non-volatile FRAM. Here is the code (replace x by 1, 2 and 3 for the three modules):

#pragma ORDER
...
#pragma NOINIT
#pragma RENAMECLASS(HDATA=FRAMx)

ezy_meas_s HUGE ezy_measx;

The classes are:

... FRAM1 (0X180000-0X18A7FF),
    FRAM2 (0X18A800-0X194FFF),
    FRAM3 (0X195000-0X19F7FF),
    FRAM (0X19F800-0X19FFFF))
    CINITTAB (0XC00000-0XC1FFFF) ...

The linker / locator places data from module 1 and 3 to the proper addresses:

180000H   18753FH   007540H   HDATA REL   WORD   ---  ---  PUBL  FRAM1   ?HD?EZY_MEAS1
195000H   19C53FH   007540H   HDATA REL   WORD   ---  ---  PUBL  FRAM3   ?HD?EZY_MEAS3

But fails to place module 2:

4086F4H   40FC33H   007540H   HDATA REL   WORD   ---  ---  PUBL  FRAM2   ?HD?EZY_MEAS2

There are no other modules which use the renamed classes FRAM1, FRAM2 and FRAM3. Does anybody have an idea why the locator fails here?

Thanks a lot
Thomas

Note
This message was edited to reduce width.