Target DLL has been cancelled with SILABS 8051Fxxx

I have download the latest driver for SILABS 8051Fxxx devices. Whern I tried to connect to my board and download code to debug the first I received a message saying I had some old drivers and if I wanted to update them, I did that and now everytime I try to connect it says "Target DLL has been cancelled Debugger aborted". Do anyone know how to fix this in order to transfer the code to the device and be able to debug it and then run the code anywhere I want? Thanks.

Parents
  • Ariel;
    Suggest that you look at this link on this discussion forum.
    http://www.keil.com/forum/docs/thread6665.asp
    Basically, it will say to remove (uninstall) any previous SiLabs Driver. Go to c:\keil\tools.ini and remove or rename the old SiLabs driver entry. Then re-install the latest Silabs Driver. After you install the new driver, go to Target->Options->Debug Tab, select the SiLabs Driver and make sure the settings match your Comm Port set up.
    Also, you can use the SiLabs Download IDE from the SiLabs website to verify your Comm to JTAG operation to eliminate any possible hardware problems.

Reply
  • Ariel;
    Suggest that you look at this link on this discussion forum.
    http://www.keil.com/forum/docs/thread6665.asp
    Basically, it will say to remove (uninstall) any previous SiLabs Driver. Go to c:\keil\tools.ini and remove or rename the old SiLabs driver entry. Then re-install the latest Silabs Driver. After you install the new driver, go to Target->Options->Debug Tab, select the SiLabs Driver and make sure the settings match your Comm Port set up.
    Also, you can use the SiLabs Download IDE from the SiLabs website to verify your Comm to JTAG operation to eliminate any possible hardware problems.

Children
More questions in this forum