HI, can any one help me to how to dump hex file into lpc2148. i m going to develop my own PCB board.i have confusion about programmer. some articles say dump via UART0 n some says JTAG. which one is easier.i m thinking go with Serial communication. so what are hardware i need to implement and how to write bootloader programming.please provide me circuit diagram with code.
"Not Recommended" is not the same as "Not Possible" - is it?
But, if the manufacturer themselves is recommending that you do not use one of their own products - don't you think that might be worth paying attention to ... ?
Again, this has nothing to do with Keil
If you want know why NXP don't recommend this chip, then it should be obvious that NXP are the people to ask?!
thank u for your reply isn't its possible to develop a new hardware using lpc21XX series..may i know the particular reason behind this..
But what does the manufacturer's datasheet say?
This should be your primary reference!
To load via UART would require a bootloader in the chip - does it have one?
You do realise that the LPC2xxx family is Not Recommended for New Designs (NRND) - don't you?
www.nxp.com/.../lpc2000-arm7-mcus:MC_71580
Note that none of this has anything to do with Keil!
View all questions in Keil forum