No matching Core found

Hai

I am facing No matching core found selecting default core ARM7.
I am not able to fuse program into my MCU ADuC 7026.
Power supply voltage is 3.3 detected by JTAG. Using MiDAS Jlink emulator

Could anyone help on this issue.

Regards
Muthu

Parents
  • Your post is rather lacking in contextual detail.

    What version of Keil uV are you using?
    What version of Segger J-Link driver and firmware are you using?
    What other information do tools like J-Link Commander tell you?

    What exactly is your project configuration, and what message(s) are you seeing during programming, or erasure?

    Are there any Midas or Analog Devices tools you can do further analysis with?

    Is this a commercial board? or one you built yourself?

Reply
  • Your post is rather lacking in contextual detail.

    What version of Keil uV are you using?
    What version of Segger J-Link driver and firmware are you using?
    What other information do tools like J-Link Commander tell you?

    What exactly is your project configuration, and what message(s) are you seeing during programming, or erasure?

    Are there any Midas or Analog Devices tools you can do further analysis with?

    Is this a commercial board? or one you built yourself?

Children
More questions in this forum