Hi All, After long time I was trying to recompile and load the firmware in MCB2300 board and uversion 4. This project was actually developed for a hardware which was developed based on MCB2300 board schematic and uversion 3.
To a maximum end i have copied the configuration of existing settings to uversion 4.
Now my problem is that program control does not reach main loop. I have a boot loader running. So here i have given the last few lines of boot loader code.
/* Run appliication at specified address */ static void cmd_run (char *par) { int run_addr; U32 i; PFV fp; run_addr = DEFAULT_RUN_ADDR; // #define DEFAULT_RUN_ADDR 0x10000 fp = (PFV)(run_addr); DEBUG_Printf("Run applicaiton at 0x%x...\n", run_addr); for (i=0x1000;i!=0; i--); (*fp)(); }
on-chip IROM1 = 0x10000 0x80000
on-chip Default IRAM1 = 0x40000040 0xFFC0 IRAM2 = 0x7FE00000 0x4000 NoInit
Can anyone point me what would be the problem here?
View all questions in Keil forum