Reply to a new post on the Read-Only thread, http://www.keil.com/forum/21035/
Ramesh goud > am working on IAR evalution board (LPC2148) for USB virtual com. The sample code from keil is not working in this board.
Did you really try it? I believe the CDC example (Keil\ARM\Boards\Keil\MCB2140\RL\USB\Device\CDC\) works on the IAR board without any change.
Here is the schematics of both boards,
Keil MCB2140 http://www.keil.com/mcb2140/mcb2140-schematics.pdf
IAR LPC2148 Development board old.iar.com/.../LPC2148-board-schematic.pdf
To run the CDC example, - Both boards mount a 12MHz crystal - MCU VBUS pin (P0.23) connects to VBUS pin of the USB connector over resistors. - DB9 connector on UART1 (COM1 / RS232_1)
The difference is just USB_CONNECT (P0.31) pin. MCB2140 doesn't use USB_CONNECT, but IAR board requires it. The example code enables USB_CONNECT function in USBD_Init(), usbd_LPC214x.c.
In these observations, I believe the Keil CDC example works on the IAR board as it is.
Tsuneo
Hello Tsuneo, i've enable the pin P0.31, now it's showing that unknown device with that code, i hope the enumeration process is not working properly,
The example code that was given by the IAR systems is working fine, it's detecting the COM over there. And he had provided the host driver to work.
Tel me some suggestion...
> The sample code from keil is not working in this board.
Err.. We may be talking about different examples. What is the "sample code" are you working on? Show the exact link or folder location.
www.nxp.com/search
Dear Tsuneo,
here am sharing the link and it contains the source code for LPC2148 USB Virtual Com. Please go through this and let me know if it's suitsble for IAR board or not, if it's, then tel me what are the changes to be needed.
Thank U...
View all questions in Keil forum