hi all
I've worked with tcp library with 4.2 version without any problem
now i switched to 4.7 version
when i program my code it works properly (answer my ping)
but when i turn it off and on (reset) it doesn't answer my ping !
thank
thank u
So you'll have to use other tools & methods - like printf to a serial port, lighting LEDs to indicate progress in the code, etc, etc,...
.
it's not a simple code to use printf or led it's just call main_TcpNet ();
and if u mean to check run system i did it
i set high one pin in my code and it works.
Do you have a Dev Kit or similar which works? If so, compare and contrast...
I've mentioned that this board works without any problem with Previous version of keil
It's your system: You have the code in front of you; You have the hardware in front of you. Nobody else has this, nor knows anything about your system -
i know all of these
therefore, you are the one who needs to get in there and get debugging
it's a bit hard to debugging tcp library !
View all questions in Keil forum