What JTAG can I use to use logic analyzer??

Hello,

I would like to use logic analyzer but I have a doubt.
I have a demo kit with ulink-me debuger but I suspect that ulink-me is not correct device to do it.

Could somebody tell me what is the correct debuger to use logic analyzer?
Ulink2 or Ulink pro?

Best regards.
John Martin

Parents
  • Hi,

    please enable SWJ in the Debug Tab and select SW instead of JTAG.
    Then you must configure the Trace Tab with the correct CPU Frequency, i.e. Timestamps: 16, and UART Mode for ULINK2/ME.

    Probably your Device needs an .ini file (selectable where you select the target driver or Simulation)

    Please have a look into the MCBSTM32 projects, the i.e. the STLib Blinky there is configured for ULINK2/ME.

Reply
  • Hi,

    please enable SWJ in the Debug Tab and select SW instead of JTAG.
    Then you must configure the Trace Tab with the correct CPU Frequency, i.e. Timestamps: 16, and UART Mode for ULINK2/ME.

    Probably your Device needs an .ini file (selectable where you select the target driver or Simulation)

    Please have a look into the MCBSTM32 projects, the i.e. the STLib Blinky there is configured for ULINK2/ME.

Children
More questions in this forum