Hi All,
Anyone knows if uVision can register the maximum stack usage in debug mode?.. Is very useful to run the code in the target and then check the maximum usage of the stack in any moment in order to be safe about the size. Perhaps anyone knows a better way to calculate it.
Thanks
Hi,
hehe... very good solution, I will do that, but, I think the debuger can do it wihtout need to write code to fill it.
I think the debuger can do it wihtout need to write code to fill it
I agree. That would be useful functionality to have.
The method described can be quite a useful indicator, but remember ...
when you look at the stack after your run don't assume it is the absolute maximum use, because it may not be. It is the use of a run up to that point. The absolute maximum would be the result of worst case nestings and might only occur infrequently.
Any such test should be done togeter with a code coverage analysis - what parts of the code was executed?
Another thing to remember is that some processors have a unified stack also including interrupts. So knowledge about the used processor is needed.