Hi,
i'm using LPC3250 to interface with micron MT48LC16M16A2(4 Meg x 16 x 4 banks) SDR SDRAM.i followed Blinky program as example and initialized for my 256Mb SDRAM.i have written data on 16-bit wide on the EMC_DYCS0_N memory location as below
#define EMC_DYSC0 (*(volatile unsigned short *)0x80000000) #define EMC_DYSC1 (*(volatile unsigned short *)0x80000002) #define EMC_DYSC2 (*(volatile unsigned short *)0x80000004) #define EMC_DYSC3 (*(volatile unsigned short *)0x80000006) #define EMC_DYSC4 (*(volatile unsigned short *)0x80000008)
writen data into memory
EMC_DYSC0 = 0x0000; write_change(); // Gives delay of 2us and send Normal command EMC_DYSC1 = 0x1111; write_change(); EMC_DYSC2 = 0x2222; write_change(); EMC_DYSC3 = 0x3333; write_change(); EMC_DYSC4 = 0x4444;
after that i'm reading back from the same locations. But i'm getting as
location 0:0000 location 1:0000 location 2:1111 location 3:1111 location 4:2222
as above data is repeating on two memory locations. Gone through data sheet of LPC3250 and SDRAM. But struck here. Please help to get out of this.
Thank you
View all questions in Keil forum