Hello to all who are reading my post.
As a beginner it would be I need some basic examples that show the manner PWM ports work connected to a relay or some thing similar. Good Day.
Avi Muzaich
PWM to a relay?
Why?
PWM is normally intended to be used to create curve shapes or varying voltages on a signal.
Did you plan to vary the drive current to the relay coil to reduce the energy consumed in the "hold" state?
Specifically I should regard that the pwm port must control a solenoid valve.
But still - why PWM?
For its higher speed into other communication protocols.
Eh??
You can make it easy for people to help you, or you can carry on making it hard for people to help you...
View all questions in Keil forum