timers/counter

i want to use an if statment to start a timer n then i want it to tell me how long it been going for and then i want it to reset when it get to a lower value. where do i start.

Parents
  • Obviously by reading the documentation for your specific processor. That information tells you how to configure the running speed of the timer. How to start it. How to stop it. How to check the current value.

    You do _not_ start by writing a forum post asking how to start. Forum posts are good when/if you get stuck somewhere.

Reply
  • Obviously by reading the documentation for your specific processor. That information tells you how to configure the running speed of the timer. How to start it. How to stop it. How to check the current value.

    You do _not_ start by writing a forum post asking how to start. Forum posts are good when/if you get stuck somewhere.

Children
More questions in this forum