Not Possible to Insert BeakPoints

I am using Keil MDK Version 4.02 and Debugger ULINK2.
With an Evalution Board from STM Based on ARM Cortex M3,
I am unable to Insert BreakPoints while debugging.
But the Firmware is running in the Board by blinking an LED.
Please let me know your comments on this?

Regards,
Favas.

Parents
  • I am using Keil MDK Version 4.02 and Debugger ULINK2.
    With an Evalution Board from STM Based on ARM Cortex M3,
    I am unable to Insert BreakPoints or step into the C Code while debugging. I can step into the disassembly code, but not the C code.
    But I am able to make the code RUN in the debug mode and also flash the code using ULink2.
    can some one put some light to this issue.

Reply
  • I am using Keil MDK Version 4.02 and Debugger ULINK2.
    With an Evalution Board from STM Based on ARM Cortex M3,
    I am unable to Insert BreakPoints or step into the C Code while debugging. I can step into the disassembly code, but not the C code.
    But I am able to make the code RUN in the debug mode and also flash the code using ULink2.
    can some one put some light to this issue.

Children
More questions in this forum