Can anyone advise on their experience (good or bad) using an In Circuit Emulator with uVison 3 for the P89LPC935 and P89LPC936 microcontrollers. I am considering the Acqura PDS900 with a P89LPC936 bondout. Any information on your experience with this or another ICE would be welcome.
Ceibo has one as well, I found it somewhat lacking compared to the Acqura but am still using it, for no other vreason than the interface is the sames as other Ceobo ICES.
Erik
EPM900 is an cost-effictive emulator for the LPC900 series. For more info see here:
http://www.keil.com/epm900/
Thanks Erik, that's very useful info. At this stage I have no feedback on other ICE's - looks like I will be grappling with some poor documentation (what's new?) but it is good to know the support is good.
I got the Acqura and used it briefly before the LPC ran out of steam and was replaced by a 100MHz SILabs.
The ICE is very good, the documentation STINKS, the device can do so much (unneeded) stuff that the learning curve is quite steep.
However, I must praise the Acqura support. they WILL get you going. (IMHO the3 Acqura support is in the top 5)
View all questions in Keil forum