Reset after success remote update

Hi All,

I managed to update my FW, but the new FW is not start to work.

I checked that the new FW is burn correctly (I verify it with uVision3 with the verify option at the utility settings).

Please advice Kobi

Parents
  • You managed to update your fw. If the verify passed, then you know that the copy operation worked.

    But that isn't a guarantee that the firmware you downloaded is correct. If you download a buggy firmware, your board may fail to start.

    In this case you are not supplying any information at all that can help us help you with your problem.

    We don't know what equipment you have updated. We don't know what the old firmware was. We don't know what the new firmware is. We don't know if it is an application that you have written/modified, or if it is a demo application.

    We don't know what indications you are looking at to deduce that the firmware doesn't run now but did run before the update.

Reply
  • You managed to update your fw. If the verify passed, then you know that the copy operation worked.

    But that isn't a guarantee that the firmware you downloaded is correct. If you download a buggy firmware, your board may fail to start.

    In this case you are not supplying any information at all that can help us help you with your problem.

    We don't know what equipment you have updated. We don't know what the old firmware was. We don't know what the new firmware is. We don't know if it is an application that you have written/modified, or if it is a demo application.

    We don't know what indications you are looking at to deduce that the firmware doesn't run now but did run before the update.

Children
More questions in this forum