• State Suggested Answer
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 18 subscribers
  • Views 1829 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Could not stop ARM device!

Alessandro

Hello.

I am trying to load my code into a LPC2129 with ULINK2 and appears an error message saying: "Could not stop ARM device! Please check the JTAG cable". I tried to change the JTAG clock to 100 kHz and did not work. I tried with another ULINK2 but nothing changes.

How can I solve the problem?

Best regards,

Alessandro

Parents
  • 0

    So a relatively old ARM7 design. Your design? Some other vendor? Board of known functionality?

    The JTAG pins might be incorrect and not actually functional. All pins? JTDI, JTDO..

    Absent NRST/NRESET to actually control the core? Check NRST state, check supplies and BOR/POR thresholding devices on board, or on chip.

    Pins getting reconfigured, or powered down. Watch for low power modes, or disabling the interface, or clocking/settings of pins.

Reply
  • 0

    So a relatively old ARM7 design. Your design? Some other vendor? Board of known functionality?

    The JTAG pins might be incorrect and not actually functional. All pins? JTDI, JTDO..

    Absent NRST/NRESET to actually control the core? Check NRST state, check supplies and BOR/POR thresholding devices on board, or on chip.

    Pins getting reconfigured, or powered down. Watch for low power modes, or disabling the interface, or clocking/settings of pins.

Children
No data