This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Getting Error " As not target connected" in STM32 controller

Hi,

I have generate led blinking project for MDK ARM Keil uvision5.25 using STM32CUbeX IDE. 
Project is compiled successfully with 0 error. 
Getting Error " As not target connected" when i try to load the firmware as per attached images. 
Connecting STM32L151CB microcontroller to ST-LINK/V2 Programmer with given 5 pin ->1) VCC 2) GND 3) SWDCLK 4) NRST 5) TMS/SWDIO

Its kind request to you to provide me the solution to resolve these error as soon as possible.

Parents Reply Children
No data