Hi everybody,
I'm currently evaluating Arm Development Studio as a replacement for uVision from Keil MDK.
I'm using the most recent version with an STM32H7, currently debugging the M7 core with an STLINK V2 - altough the problem persists with a J-LINK.
Currently, I'm struggling to properly step through code. As I have several periodic interrupts, I'm always ending up in an interrupt.
While this makes sense - interrupts occur at several kHz - this behavior is very different from how debugging worked in uVision where, while stepping through code, interrupts seem to be disabled.
I had a look through the commands listed here: https://developer.arm.com/documentation/101471/2000/Arm-Debugger-commands?lang=en but could not identify a command to disable interrupts while stepping through the code.
Is there any way/option to replicate how uVision stepped through code?
Thanks in advance, any help is highly appreciated!
Hi Sven
Thanks for your additional information. Sorry, but I still can't figure out what might be going wrong here.
I suggest you open a Support Case using the "Support > Open a Support Case" option at the top of this page, so that Arm support and engineering teams can properly investigate.
Stephen