AXI write strobes

Offline jameskim jameskim over 6 years ago

Note: This was originally posted on 21st February 2007 at http://forums.arm.com

the AXI spec says:

10.1 About unaligned transfers
[...]
For any burst that is made up of data transfers wider than one byte, it is possible that the first bytes that have to be accessed do not align with the natural data width boundary. For example, a 32-bit (four-byte) data packet that starts at a byte address of 0x1002 is not aligned to a 32-bit boundary.

and then shows some examples of bursts with unaligned first bytes.

i also see references to disabling all strobes on any beat of a burst write.

but, what about unaligned ending bytes? for example, a burst of 1kB starting at address 0x1 would have both an unaligned starting and ending byte. is this allowed?

do the bytes of a burst have to be contiguous? could the writes strobes have holes in them, for example, 0x5, 0xa, 0x9, etc.?

also, i was wondering what AXI masters ARM has that makes use of this feature? do ARM processors ever generate unaligned bursts for instruction or data accesses, or is it only the DMA controller that issues unaligned bursts? and in what scenario would a master disable all the strobes after starting a burst write (something like interrupting a dirty line castout?)?

thanks!
james

AXI write strobes

strobe 0

AXI4-Relationships between the channels 0

How to assert PSLVERR in APB4 ? 0

How AHB Arbiter should handle granting bus masters while performing only a SINGLE transfer? 0

Should the SPLIT and RETRY response be given only for NONSEQ transfer? 0