I just downloaded the "Cortex-M3 DesignStart FPGA-Xilinx edition packag" and tried to load the bitstream up to Arty A7-100T , but got error
"Incorrect bitstream assigned to device. Bitfile is incompatible for this device"
I think this package maybe created for Arty A7-35T, so it is possible does not work.
Is there a way to modify it to make it work on Arty A7-100T?
I read somewhere "The pre-built FPGA bitstream only works for Arty boards equipped with an Artix-35T FPGA. For other Arty variants (e.g. the Arty A7-100) the bitstream must be rebuilt." However the page I read didn't say how to do that.. and at this time I have no clue either. I'm in the same boat.. Unless this page is wrong, and it's not something that we can rebuild? but it's the only place with that info i could find anything about it. For starters who are just starting I would say yeah.. 35t would of been the best bet.
I did some changes in Vivado, and able to make a bit stream - but after uploadeds it into Arty A7-100T, no responses at all. I might have made some mistakes, but could not figure out where.
View all questions in Cortex-M / M-Profile forum