Hi, My name is Juan i'm starting a course in embedded sistemas and I want to have fun with DesignStart. I am interested in FPGA part.
I Just downloaded Cortex-M1 DesignStart FPGA - Xilinx Pkg.
I have Access to a PYNQ-Z1. I'm trying to figure out how to make a simple hello world! Project.
Just configure the Cortex-M1 in the PYNQ-Z1 PL and write a hello world to UART, but i don't know how to achive that...
Could you give me some hints or any information about how to do it?
Thank you for hep.
Sorry for the delay. Unfortunately I don't have the answer for this one. Have you tried contact Xilinx support?
I found out what was the issue so i'm gonna answer below in case you have the same problem:
When generating the BSP for the CM1 you have to select the ARM_SW_IP_REPOSITORY (that comes with the CM1 software) as a repository in Xilinx > Repositories on the SDK.
But when you make the BSP for the A9 you have to delete that from there, otherwise you wouldn't be able to generate correctly the A9 BSP.
So I suggest to first generate the A9 BSP, then mark ARM_SW_IP_REPOSITORY as a repository in Xilinx > Repositories and then generate the CM1 BSP. That must work properly.
Hope you find it useful,