After compiling the MPS2+ FPGA designstart project (unmodified, as-is out of the box), i'm failing to run it on the FPGA.
While the already downloaded image that arrives on the FPGA runs fine (i run the demo application), the image I compiled fails to run. After the FPGA configuration finishes the LCD remain blank, all the leds are constantly lightened and the LOG.txt (in the root directory of the board) shows the following message: "SMSC9220 initialisation failed."
Also, i see the following messages in Quartus:
I'll appreciate your advice.
Have you copied the Recovery image from CMPS3.0 onto your board (following the "System Recovery" instructions in the CMPS Getting Started guide).